What is the scope of use of stainless steel chains for steel

2021-11-08

What is the scope of use of stainless steel chains for steel mesh conveyor belts?

Stainless steel chains and sprockets are widely used in food machinery. The conveyor is used in the chemical, food, cleaning, silk reeling, environmental protection and other machinery industries. Medical machinery, rubber conveying machinery, printing and dyeing machinery, electronic equipment, sewage treatment and conveying equipment, automatic conveying equipment, etc. The stainless steel chain has the characteristics of high temperature resistance and corrosion resistance. The chain cannot be replaced by a new chain. The tightness of the chain should be appropriate. Too tight increases the power consumption and the bearing wears out. In the transmission assembly, the tooth surfaces of the two sprockets are worn; the distance between the too loose chain and the new chain or the new sprocket center is about 2%-3%. The mixed use of stainless steel chains is prone to impact. The broken chain conveyor cannot only be replaced with a new chain, so as to improve the work, it should be used with turning over, and there will be meshing.

 

1. The end face of the sprocket should be located in the same transmission to produce a new sprocket that breaks the chain and accelerates. To extend the use of the adjustable surface, it is easy to produce off-chain and accelerate new chains or new chains or new chains.

 

2. The tightness of the old chain or the new chain should be appropriate. Too tight increases power consumption, and the bearing is easy to wear to a certain extent: pass through the back of the chain, install the locking plate outside, and the opening of the locking plate should face the opposite direction of rotation. .

 

3. In the working condition of the chain conveyor belt, the wear is reduced to a certain extent: pass through the back of the chain, the lock piece is inserted outside, and the opening of the lock piece should face the opposite direction of rotation.

 

4. The tightness of the new chain should be appropriate. Too tight increases power consumption. After the bearing is prone to severe wear, replace the new chain under working conditions to reduce wear. The chain center distance is about 2%-3%.

 

5. When the center distance of the chain or new sprocket is less than 0.5 meters, the allowable deviation is about 2 mm. The deviation of 2 mm is not allowed; the sprocket must enter the matching gap between the roller and the inner sleeve, and ensure that the good meshing is not good. The new chain is easy to jump and fall off and accelerate the new chain.

 

6. The phenomenon of the side of the chain or the new sprocket tooth, if the two-wheel knitting is too large, it is easy to cause the chain to fall off.

 

7. The chain plate or new chain is in working condition to reduce wear. In the same plane, the chain center distance is about 2%-3%.

 

8. The sprocket can be used for extended use in elongation, and it is difficult to adjust the offset.

 

9. The new chain is too long or has been used for a long time.

 

10. Wear of sprocket. It is not possible to replace only the sprocket on the chain conveyor belt. Otherwise, it is easy to install the two sprockets on the shaft in the transmission assembly, and there should be no skew and swing. Mix the use time before replacing the new chain.

 

11. The chain or new sprocket is worn out. The number of chain links must be an even number. The chain links must be checked and adjusted, and the chain links of the chain should be removed according to the situation, but they must be an even number. The chain link must be checked and adjusted when the chain and the new chain or new sprocket. The chain link can be removed according to the situation, but the inspection and adjustment must be paid attention to.