the conveyor belt

2021-09-15

If the load of the conveyor belt is too large, it will slip if it exceeds the electric capacity. The advantage of slip at this time is that it protects electricity. Otherwise, the electricity will be burned after a long time. But for operation, it is a slip accident. So what are the adjustment methods and factors for the conveyor belt to prevent slippage? Learn more below!

1. The initial tensile strength is not large. Insufficient tensile force at the place where the conveyor mesh belt gets rid of the drum causes the conveyor belt to deviate. This kind of situation is generally caused by starting, and the solution is to adjust the tensioning device to increase the initial tensile strength.

 

2. The sliding friction between the transmission roller and the conveyor belt is not enough to cause deviation. Most of the unnecessary elements are wet on the conveyor belt or the natural environment is too humid. The solution is to add some turpentine powder to the drum. But it should be noted that it is not necessary to add force, but use centrifugal fan machinery and equipment to blow in to prevent safety production accidents.

 

Adjusting methods and factors for preventing and controlling slippage of conveyor mesh belt

 

3. The end roller bearing is damaged and does not rotate, or the left and right roller bearings are damaged and do not rotate too much. The main cause of damage was excessive tail ups and downs, and the failure to repair and disassemble the prefabricated components that were damaged or rotated inflexibly, which caused the frictional resistance to increase and cause deviation.

 

4. Too fast starting speed can also cause deviation. You can start at a slow speed at this time. If the winding motor is used, it can be restarted after 2 jogs, and it can also get rid of the deviation condition reasonably.

 

5. If the load of the conveyor belt is too large, it will run off if the electric working capacity is exceeded. At this time, the beneficial side of deviation is that it has a maintenance effect on electricity. Otherwise, the electricity will be damaged after a long time. But for the operation, it is a deviation safety accident. To get rid of the deviation of the conveyor belt, the first thing to look for is the deviation factor, and then measures can be taken to solve the problem.