How to operate the mesh belt chain tightness?

2021-05-26

These are the primary scheduling methods for the tightness of the mesh belt chain. We must make reasonable adjustments according to the instructions. As long as we can fully display the functions, how to operate the tightness of the chain?

There are many types of mesh belts. Push-rod conveyor belts are the most common one used in daily life. Other herringbone conveyor belts, mesh belts, and double-eye conveyor belts can be added to drive chains according to specific regulations. The function of the chain is to prevent misalignment of the direction during the whole transportation process.

Everyone can use the wrench of production scheduling to schedule 90-degree hard and dangerous production every time; just adjust to the appropriate tightness, and be able to persevere with very good consistency. What everyone is required to pay attention to is that in the adjustment, you should keep in mind that it is appropriate The looser ones are better.

Because when the rear axle tenon anchor bolts are tightened, they will need to be tightened further than when they are loosened! In addition, assuming that the material transmission chain is too tight, just use a spanner to loosen the production scheduling anchor bolts on both sides. The same angle of view is enough. It is best to upgrade the level at 90 degrees to loosen the production scheduling anchor bolts. Then, try to see if the tightness of the material transmission chain is almost the same.

This is the main production scheduling method for the tightness of the mesh belt drive chain. Everyone must show that they carry out effective adjustments based on the evidence. Only then can its function be fully demonstrated and produce higher work economic benefits for everyone.