Explain the edge banding technology of metal decorative mesh

Edge Banding We know that the edge banding of stainless steel rope nets is also manual edge banding. Therefore, it requires two workers to cooperate before adjusting. In the meantime, one needs to take a small hammer for hitting, and the other workers need to cut the net. The surface is fixed so that it can be adjusted for accurate strikes.

    At the beginning of the beating, the workers should pay attention to safety. Since these are ironware, they may cause damage if they are not careful. So be careful. So how does this process go on! When a few of us started to spread out the mesh and then level it. Stretching is also needed in this process. We will shorten the net surface during storage, which is good for transportation. Otherwise, only shipping items will require a lot of vehicles. It is precisely because the net surface can be stretched. Stretching and shortening, so we use it like this.

    The mess of hitting is that the edge banding of stainless steel rope net per square meter reaches 2,000 times. This is still a skilled worker master, and the adjustment is complete. If you are not skilled in hitting 4000-5000 times, it is possible. When the edge banding is started, displacement must be carried out, because the net buckle must be displaced per square meter before it can be adjusted enough for subsequent strikes. This increases the difficulty of hitting, and at this time, it is necessary to move and knock to the channel. This requires two people to work hard to adjust enough to move. Visible light is the edge banding, which is very messy.

    Customized production: stainless steel rope nets, animal fences, stainless steel buckle nets, stainless steel wire rope nets, special zoo nets, special nets for animal cages, special nets for birdhouses, rope nets for decoration, stainless steel decoration protective rope nets, steel wire rope nets, green Plant climbing rope nets, bridge protective stainless steel rope nets, stadium fences, etc.